Lumber Grading And Board Defects

Lumber grading can be strict in order to give consumers reliable ratings.

Lumber used for outdoor construction like decking comes in many grades.

People just like you who are planning to build something like a deck or any outdoor structure for that matter, benefit by a good grading system.

Imagine if deck boards were piled up with random quality?

What a mess that would be. Knots, checks, warping, bows, cupping and on and on it goes. Plus some nice clear knot free boards in that pile as well.

That would be a huge time waster and no help to anybody.

Grading lumber covers things such as size, number and spacing of knots, milling defects and any special curing techniques.

Uses For Each Lumber Grade

There are three grades, No. 1, No. 2 and No. 3.

All the various kinds of physical shape changes that can occur to lumber as it dries out.

The lower the number the higher quality the grade of lumber.

There can be varieties within each grade such as No.1 Select Tight Knot, Standard Tight Knot or Clear.

No.1 grade

Lumber is usually from older growth trees so the grain is tighter and contains more heartwood so they look better, are more expensive and resist rot the best.

This kind of lumber is great for areas that are visible and exposed to the weather.

No.2 grade

Allows for more knots but is still good for weather resistance as it does not usually contain much if any sapwood. It's also less expensive so is probably your best value. And most building codes call for No.2 or better material.

No.3 grade

Allows for more knots but also tends to be less structurally sound so it is not a good choice for structural framing and its aesthetics makes it unsuitable for visible decking or railing.

This grade of lumber is used sometimes for non-structural uses that don't have to look great.

Common Defects of Deck Boards Or Joists

Knots

This is the most common grading issue with boards - the number and size of knots. Lets are more desirable but much more rare and therefore more expensive.

Knots on board

Check

This is opening parallel with the grain, running lenghtwise with the board and looks a bit like an open fault line in the earth would. Checks occur when the surface of a board dries faster than the inside.

Checked board

Crook

 

This is a bend in the board from end to end along the thin narrow edge.

Crooked board
Bow

This is a bend in the board from end to end along the wide flat face.

Bowed board
Split

This is a crack that occurs at the end of board and affects the strength of the lumber.

Split board

Cup

This is a bend across the width of board and comes to mind when you see deck boards that "cup" or hold rain water.

Cupped board

Twist

Imagine taking a board and turning each end in opposite directions like a screw. The result is a twist in the board.

Twisted board

Wane

This refers to an edge or shoulder along the length of a board that is missing or comprised of bark or sapwood.

Wane on board

Pitch

Theses are little ugly holes or cavities along the surface of a board where sap used to run. It may look like termite damage but it is very different than that.

Some species of wood are known for more sap than others.

Pitch pockets

Some Other Great Reading...

This is not an exhaustive list of how lumber grading is done but it should give you a good idea of what most of these terms mean the next time you are roaming the ailes of you lumber store.

But just in case there is something else you are looking for, there's more.

Back to Top of Lumber Grading

New! Comments

Have your say about what you just read! Leave me a comment in the box below.

© 2004-2016 By Rich Bergman, Decksgo.com. All Rights Reserved.